Suzuki sq-416-420-625 Service Manual page 475

Type-2
1. Inner end of interlock cable
2. Key release cam
Type-2
1. Key release cam
2. Cable outer
(a)
TYPE-2
5) With key release cam set as shown at the left figure, connect
inner end of interlock cable to key release cam. (Select lever
side.)
6) Move key release cam so that it is set at such angle as shown
at the left figure and with special tool inserted in hole A , fix key
release cam.
Special Tool
(A): 09925-78210 (6 mm)
7) With key release cam fixed with special tool, install cable outer
to bracket and after making sure that cable outer is pushed in
arrow direction B by leaf spring, tighten mounting nut to speci-
fied torque. Remove special tool.
Tightening Torque
.
(a): 13 N m (1.3 kg-m, 9.5 lb-ft)
8) Turn ignition key to "ACC" position and shift select lever to "N"
range, and check for the followings.
a. When select lever is shifted at "P" range with knob button
depressed, ignition key can not be turned from "ACC" to
"LOCK" position.
b. When knob button is released, ignition key can be turned to
"LOCK" position.
c. When ignition key is at "LOCK" position, select lever can not
be shifted from "P" to any other range.
9) Install console box.
10) Install steering column cover.
11) Adjust steering column or tighten steering column bolts.
12) Install steering column hole cover.
13) If equipped with air bag system, enable air bag system.
Refer to "Enabling Air bag System" in Section 10B.
AUTOMATIC TRANSMISSION (4 A / T) 7B1-73