Suzuki sq-416-420-625 Service Manual page 221

Type A Type B
1. Oil seal
2. Drive shaft
3. Drive shaft
thrust washer
D Tighten wheel spindle nut to specified torque.
Tightening Torque
(a): 50 N
D For 4WD vehicle
Press-fitting inner oil seal.
Drive in inner oil seal until its end contacts stepped surface of
knuckle by using special tools.
Special Tool
(B): 09944-66010
(C): 09924-74510
D For 4WD vehicle
D Apply lithium grease to oil seal lip and into its hollow to fill more
than 60% of its vacant space.
D Apply lithium grease "A" to drive shaft.
"A": Grease 99000-25010
D Press-fit front drive shaft thrust washer to drive shaft, if it is re-
moved (for Type B drive shaft thrust washer). Apply lithium
grease "A" to drive shaft thrust washer.
"A": Grease 99000-25010
D Apply lithium grease "A" and install front drive shaft thrust wash-
er with its chamfered side facing to center side (for Type A drive
shaft thrust washer).
"A": Grease 99000-25010
D For 2WD vehicle
Remove grease, old sealant and dusts from mating surfaces of
knuckle cap and knuckle to clean, apply water tight sealant to cap
mating surface evenly, and install cap to knuckle.
"B": Sealant 99000-31090
1. Knuckle
2. Knuckle cap
3. Wheel spindle
.
m (5.0 kg-m, 36.5 lb-ft)
FRONT SUSPENSION 3D-19