Suzuki sq-416-420-625 Service Manual page 721

DIAGNOSTIC TROUBLE CODE TABLE (Page 2 of 2)
DIAGNOSTIC TROUBLE CODE
NO. MODE
41
42
43
44
45
46
47
48
51
61
71
NOTE:
D When 2 or more codes are indicated, the lowest numbered code will appear first.
D If a code not listed on the table is displayed, then the SDM is faulty.
D Current DTC and history DTC can be identified by lighting and flashing of "AIR BAG" warning lamp as
follows.
"AIR BAG" warning lamp
after ignition switch ON
"AIR BAG" warning lamp
when grounding diagnosis
switch
However, if a multiple number of DTC's are set an even one of them is a current DTC, "AIR BAG" warning
lamp remains on after ignition switch is turned ON. Therefore, it is not possible to identify any of them
as to whether it is a current one or a history one. (But use of scan tool (Tech 1) will make identification
possible.)
Resistance high
Driver
Resistance low
pretensioner
circuit
Short to ground
(if equipped)
Short to power circuit
Resistance high
Passenger
Resistance low
pretensioner
circuit
Short to ground
(if equipped)
Short to power circuit
SDM Frontal crash detected
"AIR BAG" warning lamp circuit
SDM Internal fault
Current DTC is set.
(Abnormality exists at present.)
Remains ON.
Current DTC is displayed.
DIAGNOSIS DIAGNOSIS
Diagnose trouble
according to "Diagnos-
tic Flow Table" corre-
s onding to each code sponding to each code
No.
History DTC is set only. (Faulty condi-
tion occurred once in the past but nor-
mal condition is restored at present.)
Flashing 6 times and turns OFF.
History DTC is displayed.
AIR BAG SYSTEM 10B-15
di t "Di