Suzuki sq-416-420-625 Service Manual page 217

1. Front wheel speed sensor
2. Bolt
7) For 4WD vehicle, apply lithium grease to front drive shaft wash-
er and front wheel spindle outer.
"A": Grease 99000-25010
8) For 4WD vehicle, when installing circlip to drive shaft, utilize
screw hole in drive shaft to pull it out and bring large diameter
of circlip at right as shown.
1. Circlip
2. Large diameter
9) For vehicle with ABS, check that no foreign material is attached
to sensor and rotor. Install wheel speed sensor and its harness
clamp.
2, (b)
Tightening Torque
(a): 10 N
(b): 23 N
1
CAUTION:
D Do not pull wire harness or twist more than necessary
D Fit harness grommet to inner fender securely.
Check that there is no clearance between sensor and knuckle.
10) Install brake disc and caliper assembly.
Tightening Torque
(e): 85 N
.
m (1.0 kg-m, 7.5 lb-ft)
.
m (2.3 kg-m, 17.0 lb-ft)
when installing front wheel speed sensor.
.
m (8.5 kg-m, 61.5 lb-ft)
FRONT SUSPENSION 3D-15