Dodge ram truck 3500 1996 Service Manual page 1421

B R NV3500 MANUAL TRANSMISSION 21 - 31
DISASSEMBLY AND ASSEMBLY
( C o n t i n u e d )
(4) Install pilot bearing in input shaft (Fig. 99).
Fig. 99 Installing Pilot Bearing In Input Shaft
(5) Install fourth speed synchro ring on input shaft
(Fig. 100).
Fig. 100 Installing Fourth Speed Synchro Ring On
Input Shaft
(6) Adjust height of idler gear pedestal on assem­
bly fixture (Fig. 101). Start with a basic height of
18.4 cm (7-1/4 in.). Final adjustment can be
made after gear is positioned on pedestal.
(7) Install assembled output shaft and geartrain in
input shaft (Fig. 102). Carefully rotate output shaft
until fourth speed synchro ring seats in synchro hub
and sleeve.
(8) Install Adapter 6747-2 on front bearing
hub of countershaft, if not previously done. The
adapter has a shoulder on one side. The shoul­
der goes toward the countershaft.
Fig. 101 Idler Pedestal Basic Height Adjustment
J9421-95
Fig. 102 Output Shaft And Geartrain Installed In
Input Shaft