Dodge ram truck 3500 1996 Service Manual page 1366

14 - 132 FUEL SYSTEM B R
R E M O V A L A N D I N S T A L L A T I O N (Continued)
SENSOR
ELECTRICAL
CONNECTOR
TRANSMISSION
EXTENSION
HOUSING
J 9 4 1 4 - 6 0
Fig. 43 Vehicle Speed Sensor Location—Typical
SPEEDOMETER
PINION GEAR
ELECTRICAL
CONNECTOR
O-RING
\
SENSOR
MOUNTING
BOLT
SPEEDOMETER PINION
GEAR ADAPTER
VEHICLE
SPEED
SENSOR
O-RING
J9314-188
Fig. 44 Sensor Removal/Installation
INSTALLATION
(1) Clean the inside of speedometer pinion gear
adapter before installing speed sensor.
(2) Install sensor into speedometer gear adapter
and install mounting bolt. Before tightening bolt,
verify speed sensor is fully seated (mounted
flush) to speedometer pinion gear adapter.
(3) Tighten sensor mounting bolt to 2.2 N-m (20 in.
lbs.) torque.
(4) Connect electrical connector to sensor.
WATER-IN-FUEL SENSOR
The water-in-fuel sensor is located at the bottom of
the fuel filter/water separator. Refer to Fuel Filter/
Water Separator in this section of the group for
removal and installation procedures.
S P E C I F I C A T I O N S
ENGINE DATA PLATE SPECIFICATIONS
If anything differs between the specifications found
on the Engine Data Plate, and the specifications used
in this manual, use specifications on data plate. The
Engine Data Plate is located on the engine timing
gear cover (Fig. 45).
TIMING
GEAR
COVER
I N G
V - 4
Fig. 45 Engine Data Plate Location
TOiOUE
SPECIFICATIONS—DIESEL
DESCEIPTION TORQUE
Engine Speed Sensor
Nuts/Bolts .24 N-m (18 ft. lbs.)
Intake Manifold Air Temp.
Sensor 28 N-m (20 ft. lbs.)
Intake Manifold Air Heater
Relay Bolts .4.5 N-m (40 in. lbs.)
PCM Mounting Bolts . .4 N-m (35 in. lbs.)
Vehicle Speed Sensor
Mounting Bolt .2.2 N-m (20 in. lbs.)