Dodge ram truck 3500 1996 Service Manual page 1343

B R
FUEL SYSTEM 1 4 - 1 0 9
REMOVAL AND INSTALLATION (Continued)
FUEL
DRAIN
MANIFOLD
FITTING
HIGH-PRESSURE
FUEL LINE
HIGH-PRESSURE
FUEL LINES (6)
FUEL INJECTOR
J 9 4 1 4 - 1 17
Fig. 116 Fuel Lines at Fuel Injectors
FITTINGS (6)
FUEL DELIVERY
VALVE HOLDERS (6)
INJECTION PUMP
J9414-H6
Fig. 117 Fuel Delivery Waive Holders and Pressure
Lines
CAUTION: Be sure that the high-pressure fuel
lines are installed in the same order that they were
removed. Prevent the injection pump delivery vaive
holders from turning when removing or installing
high-pressure lines from injection pump.
INSTALLATION
(1) Carefully position each high-pressure fuel line
to the fuel injector and fuel injection pump delivery
valve holder in the correct firing order. Also position
each line in the correct line holder.
(2) Loosely install the line clamp isolator and
bracket holder bolts.
(3) Tighten each line at the delivery valve holder
to 24 N-m (18 ft. lbs.) torque.
(4) Tighten each line at the fuel injector to 24 N-m
(18 ft. lbs.) torque.
CAUTION: Be sure the lines are not contacting
each other or any other component.
(5) Tighten the clamp bracket bolts to 24 N-m (18
ft. lbs.) torque.
(6) Bleed air from the fuel system. Refer to High-
Pressure Fuel Line Bleeding in the Air Bleed Proce­
dure portion of this section.
THROTTLE CABLE
CAUTION: Be careful not to damage or kink the
cable core wire (within the cable sheathing) while
servicing accelerator pedal or cables.
REMOVAL
(1) From inside the vehicle, hold up the accelerator
pedal. Remove the plastic cable retainer and throttle
cable core wire from upper end of pedal arm (Fig.
118). The plastic cable retainer snaps into pedal the
arm.
CABLE
STOP
FRONT O F
C^-v
VEHICLE
PINCH T W O
TABS
FOR
CABLE REMOVAL
THROTTLE
PEDAL
ARM
J9414-42
Fig. 118 Cable Removal/Installation