Dodge ram truck 3500 1996 Service Manual page 1257

BR
FUEL SYSTEM 14 - 23
REMOVAL AND INSTALLATION (Continued)
(a) Connect cable end socket to throttle body
lever ball (snaps on) (Fig. 40).
(b) Connect cable to throttle body mounting
bracket (push down and lock).
(3) Install the remaining cable housing end into
and through the dash panel opening (snaps into posi­
tion). The two plastic pinch tabs (Fig. 37) should lock
the cable to dash panel.
(4) From inside the vehicle, hold up the accelera­
tor pedal. Install the throttle cable core wire and
plastic cable retainer into and through the upper end
of the pedal arm (the plastic retainer is snapped into
the pedal arm). When installing the plastic retainer
to the accelerator pedal arm, note the index tab on
the pedal arm (Fig. 37). Align the index slot on the
plastic cable retainer to this Index tab.
S P E C I F I C A T I O N S
VECI LABEL SPECIFICATIONS
If anything differs between the specifications found
on the Vehicle Emission Control Information (VECI)
label and the following specifications, use specifica­
tions on VECI label. The VECI label is located in the
engine compartment.
FUEL TANK CAPACITY
Models Liters
U.S. Gallons
118" Wheelbase
98
26
All Other Models 132 35
Nominal refill capacities are shown. A variation may
be observed from vehicle to vehicle due to
manufacturing tolerance and refill procedure.
FUEL SYSTEM P R E S S U R E
All Engines: 339 kPa ± 34 kPa (49.2 psi ± 5 psi)
TORQUE SPECIFICATIONS
DESCRIPTION TORQUE
Fuel Pump Module Locknut 54 N-m (40 ft. lbs.)
Fuel Rail Mounting Bolts—
3.9L/5.2L/5.9L Engines 23 N-m (200 in. lbs.)
Fuel Rail Mounting Bolts—
8.0L Engine .15 N-m (136 in. lbs.)
Fuel Tank Mounting Nuts . . . . . .41 N-m (30 ft. lbs.)
Fuel Hose Clamps 1 N-m (15 in. lbs.)