Dodge ram truck 3500 1996 Service Manual page 1251

B R — _ — •
R E M O V A L
AND INSTALLATION
( C o n t i n u e d )
FUEL
INJECTOR J9214-30
Fig. 27 Fuel injector Connectors—Typical
Fig. 28 EVAP Canister Purge Solenoid—Typical
fold. Repeat this procedure (left/right) until all fuel
injectors have cleared the intake manifold.
(12) Remove fuel rail (with injectors attached)
from engine.
(13) Remove the clip(s) retaining the injector(s) to
fuel rail (Fig. 29) or (Fig. 30).
INSTALLATION
(1) Apply a small amount of engine oil to each fuel
injector o-ring. This will help i n fuel rail installation.
FUEL SYSTEM 14 -17
INJECTOR J9214-24
Fig. 29 Fuel Injector Mounting—Typical
PLIERS
J9414-156
Fig. 30 Injector Retaining Clips—Typical Injector
(2) Install injector(s) and injector clip(s) to fuel
rail.
(3) Position the fuel rail/fuel injector assembly to
the injector openings on the intake manifold.
( 4 ) Guide each injector into the intake manifold.
Be careful not to tear the injector o-ring.
( 5 ) Push the r i g h t fuel rail down until fuel injec­
tors have bottomed on injector shoulder. Push the
left fuel rail down until fuel injectors have bottomed
on injector shoulder.
(6) Install fuel rail mounting bolts.
(7) Install EVAP canister purge solenoid to intake
manifold.
(8) Connect electrical connector to intake manifold
air temperature sensor.
( 9 ) Connect wiring to all fuel injectors. The injec­
tor wiring harness is numerically tagged.