R E M O V A L A N D I N S T A L L A T I O N (Continued)
F U E L U N E
( T O F U E L RAIL)
DRIVER' S SIDE
E L E C T R I C A L
CONNECTOR
EVAP
H O S E
F U E L F I L T E R /
F U E L P R E S S U R E
R E G U L A T O R
F U E L T A N K
( G A S
P O W E R E D )
J9414-37
Fig. 34 Fuel Tank Connections—Gas
Powered
Engines
(a) While working over the left rear tire/wheel,
disconnect the electrical connector from the fuel
pump module (Fig. 34).
(b) Disconnect the EVAP hose at the pressure
relief/rollover valve (Fig. 34).
(c) Disconnect the fuel supply line at the fuel fil
ter/fuel pressure regulator (Fig. 34). Refer to
Quick-Connect Fittings for procedures.
(6) Diesel Powered Engines:
(a) While working over the left rear tire/wheel,
disconnect the electrical connector from the fuel
tank module (Fig. 35).
(b) Disconnect the fuel supply and fuel return
lines at the fuel tank module (Fig. 35). Refer to
Quick-Connect Fittings for procedures.
(7) Place a transmission jack under the center of
the fuel tank. Apply a slight amount of pressure to
fuel tank with transmission jack.
WARNING: WRAP SHOP TOWELS AROUND HOSES
TO CATCH ANY GASOLINE SPILLAGE.
(8) Remove the fuel tank mounting strap nuts at
the mounting straps (Fig. 36). I f equipped, remove
the fuel tank heat shield bolts (Fig. 36).
F U E L R E T U R N
A N D S U P P L Y U N E S
DRIVER'S SIDE
OF VEHICLE
DRIVER' S
SIDE
OF VEHI C LE
HEAT
S H I E L D
F U E L
T A N K
( D I E S E L )
J9414-38
STRAP MOUNTING
NUTS
J9414-39
Fig. 35 Fuel Tank Connections—Diesel
Powered
Engines
(3) Drain fuel tank. Refer to the previous Draining
Fuel Tank section.
(4) Disconnect both the fuel fill and fuel vent rub
ber hoses at the fuel tank (Fig. 33).
(5) Gas Powered Engines:
Fig. 36 Fuel Tank Mounting—Typical
(9) Lower fuel tank for removal.
TANK
INSTALLATION
(1) Place fuel tank on top of transmission jack.
( 2 ) Raise tank into position in the frame cross-
members.
(3) Connect the two mounting straps and mount
ing strap nuts.