Dodge ram truck 3500 1996 Service Manual page 1300

14 - 66 FUEL SYSTEM BR
REHOWAL AND INSTALLATION (Continued)
(3) Remove sensor from intake manifold.
Fig. 100 Engine Coolant Temperature Sensor—8.0L
Engine
INSTALLATION
(1) Install sensor.
(2) Tighten to 11 N-m (8 ft. lbs.) torque.
( 3 ) Connect electrical connector to sensor.
(4) Replace any lost engine coolant. Refer to Group
7, Cooling System.
INTAKE MANIFOLD AIR TEMPERATURE SENSOR—
3.9L/5.2L/5.9L ENGINES
The intake manifold air temperature sensor is
located in the front/side of the intake manifold (Fig.
101) or (Fig. 102).
REMOVAL
(1) Remove air cleaner assembly.
(2) Disconnect electrical connector at sensor (Fig.
101) or (Fig. 102).
(3) Remove sensor from intake manifold.
Fig. 101 Air Temperature Sensor—3.9L (V-6) Engine
Fig. 102 Air Temperature Sensor—5.2L/5.9L (V-8)
Engines
INSTALLATION
(1) Install sensor to intake manifold. Tighten to 28
N-m (20 ft. lbs.) torque.
(2) Install electrical connector.
(3) Install air cleaner.
INTAKE MANIFOLD AIR TEMPERATURE SENSOR—
8.0L ENGINE
The intake manifold air temperature sensor is
located in the side of the intake manifold near the
front of throttle body (Fig. 103).
REMOVAL
(1) Disconnect electrical connector at sensor.
(2) Remove sensor from intake manifold.
Fig. 103 Air Temperature Sensor—8.0L Engine
INSTALLATION
(1) Install sensor to intake manifold. Tighten to 28
N-m (20 ft. lbs.) torque.
(2) Install electrical connector.