B R
FUEL SYSTEM
14 - 99
REMOVAL
A N D I N S T A L L A T I O N
fContinued)
(12) Remove the overflow valve and fuel return
line at pump (Fig, 85). Place a rag beneath the fitting
t o
catch
e x c e s s
fuel.
Fig. 85 injection Pump Overflow Valve
(13) Disconnect the s i x (6) high-pressure fuel lines
from the fuel delivery valve holders at the top of
injection pump (Fig. 86). For procedures, refer to
High-Pressure Fuel Lines in this group. Place a rag
beneath the fittings to catch excess fuel.
INJECTION PUMP
J9414-116
Fig. 86 Fuel Delivery Valve Holders and Pressure
Lines
(14) Disconnect the engine oil supply line at side of
pump (Fig. 87).
Fig. 87 Engine Oil Supply Line—Pump
Mounting
Nuts
(15) Remove the oil fill tube bracket mounting bolt
(Fig. 88).
(16) Remove oil fill tube from tube-to-gear housing
adapter (Fig. 88). Tube is removed by screwing coun
terclockwise from adapter.
Fig. 88 Oil Fill Tube, Adapter and Mounting Bracket
(17) Remove oil fill tube adapter from gear hous
ing (Fig. 88). Adapter is removed by screwing coun
terclockwise from gear housing.
(18)
The engine is equipped with a built-in
moveable timing pin. This pin is located above the
power steering pump, below and to the inside of the
fuel injection pump, on the rear of the cam gear
housing (Fig. 89). The pin will engage into a