Dodge ram truck 3500 1996 Service Manual page 1301

BR
FUEL SYSTEM 14 - 67
REMOVAL AND INSTALLATION (Continued)
VEHICLE SPEED SENSOR
The vehicle speed sensor Is located on the speed­
ometer pinion gear adapter (Fig. 104). The pinion
gear adapter is located on the extension housing of
the transmission (drivers side).
SENSOR
ELECTRICAL
CONNECTOR
J9414-60
Fig. 104 Vehicle Speed Sensor Location—Typical
SPEEDOMETER
P I N I O N GEAR
SPEED
SENSOR J9314-188
Fig. 105 Sensor Removal/Installation
REMOVAL
(1) Raise and support vehicle.
(2) Disconnect the electrical connector from the sensor.
(3) Remove the sensor mounting bolt (Fig. 105).
(4) Remove the sensor (pull straight out) from the
speedometer pinion gear adapter (Fig. 105). Do not
remove the gear adapter from the transmission.
INSTALLATION
(1) Clean the inside of speedometer pinion gear
adapter before installing speed sensor.
(2) Install sensor into speedometer gear adapter
and install mounting bolt. Before tightening bolt,
verify speed sensor is fully seated (mounted
flush) to speedometer pinion gear adapter.
(3) Tighten sensor mounting bolt to 2.2 N-m (20 in.
lbs.) torque.
(4) ' Connect electrical connector to sensor.
S P E C I F I C A T I O N S
VECi LABEL SPECIFICATIONS
If anything differs between the specifications found
on the Vehicle Emission Control Information (VECI)
label and the following specifications, use specifica­
tions on VECI label. The VECI label Is located in the
engine compartment.
TORQUE SPECIFICATIONS
DESCRIPTION TORQUE
Air Cleaner Housing Mount.
Nuts—8.0L Engine . . . . . 11 N-m (96 in. lbs.)
Air Cleaner Housing Metal Clamp—
3.9L/5.2L/5.9L Engines .4 N-m (35 in. lbs.)
Crankshaft Position Sensor Mounting
Bolts—All Engines 8 N-m (70 in. lbs.)
Camshaft Position Sensor Mounting—
8.0L Engine 6 N-m (50 in. lbs.)
Engine Coolant Temperature
Sensor—All Engines 11 N-m (96 in. lbs.)
Fuel Tank Mounting Nuts 41 N-m (30 ft. lbs.)
Fuel Hose Clamps . .1 N-m (10 in. lbs.)
IAC Motor-To-Throttle Body Bolts .7 N-m (60 in. lbs.)
Intake Manifold Air Temp. Sensor—
All Engines 28 N-m (20 ft. lbs.)
MAP Sensor Mounting Screws—
3.9L/5.2L/5.9L Engines 3 N-m (25 in. lbs.)
MAP Sensor Mounting Screws—
8.0L Engine . 2 N-m (20 in. lbs.)
Oxygen Sensor—All Engines . . . .30 N-m (22 ft. lbs.)
Powertrain Control Module Mounting
Screws 4 N-m (35 in. lbs.)
Throttle Body Mounting Bolts—
3.9L/5.2L/5.9L Engines . 23 N-m (200 in. lbs.)
Throttle Body Mounting Bolts—
8.0L Engine 22 N-m (192 in. lbs.)
Throttle Position Sensor Mounting
Screws—All Engines 7 N-m (60 in. lbs.)
Vehicle Speed Sensor Mounting
Bolt . . . . . .2.2 N-m (20 in. lbs.)