Dodge Dakota Sport 2001 Service Manual page 1521

21 - 112 AUTOMATIC TRANSMISSION - 42RE
AUTOMATIC TRANSMISSION - 42RE (Continued)
(e) Turn drum back and forth. Drum should rotate
freely in clockwise direction and lock in counter-
clockwise direction (as viewed from front of case).
Fig. 37 Installing Low-Reverse Drum
1 - REAR BAND
2 - LOW-REVERSE DRUM
(7) Install snap-ring that secures low-reverse drum
to hub of overdrive piston retainer (Fig. 38).
(8) Install rear band lever and pivot pin (Fig. 39).
Align lever with pin bores in case and push pivot pin
into place.
(9) Install planetary geartrain assembly (Fig. 40).
Fig. 38 Installing Low-Reverse Drum Retaining
Snap-Ring
1 - LOW-REVERSE DRUM
2 - HUB OF OVERDRIVE PISTON RETAINER
3 - LOW-REVERSE DRUM SNAP-RING
Fig. 39 Rear Band Lever And Pivot Pin Installation
1 - REAR BAND LEVER
2 - LEVER PIVOT PIN
Fig. 40 Installing Planetary Geartrain
1 - PLANETARY GEARTRAIN AND INTERMEDIATE SHAFT
ASSEMBLY
(10) Install thrust plate on intermediate shaft hub
(Fig. 41). Use petroleum jelly to hold thrust plate in
place.
(11) Check seal ring on rear clutch retainer hub
and seal rings on input shaft (Fig. 42). Also verify
that shaft seal rings are installed in sequence shown.
(12) Install rear clutch thrust washer (Fig. 43).
Use additional petroleum jelly to hold washer in
place if necessary.
AN