Rear Retainer Bushing And Seal; Removal; Installation - Dodge Dakota Sport 2001 Service Manual

21 - 598 TRANSFER CASE - NV244
REAR RETAINER BUSHING
AND SEAL

REMOVAL

(1) Raise vehicle.
(2) Remove rear propeller shaft. (Refer to 3 - DIF-
FERENTIAL & DRIVELINE/PROPELLER SHAFT/
PROPELLER SHAFT - REMOVAL)
(3) Using a suitable pry tool or slide-hammer
mounted screw, remove the rear retainer seal.
(4) Using Remover 8158, remove the bushing from
rear retainer (Fig. 86).
Fig. 86 Rear Retainer Bushing Removal
1 - REMOVER 8158
2 - REAR RETAINER BUSHING

INSTALLATION

(1) Clean fluid residue from sealing surface and
inspect for defects.
(2) Position replacement bushing in rear retainer
with fluid port in bushing aligned with slot in
retainer.
(3) Using Installer
retainer until installer seats against case (Fig. 87).
(4) Using Installer D-163, install seal in rear
retainer (Fig. 88).
(5) Install the rear propeller shaft. (Refer to 3 -
DIFFERENTIAL &
SHAFT/PROPELLER SHAFT - INSTALLATION)
(6) Verify proper fluid level.
(7) Lower vehicle.
8157, drive bushing
DRIVELINE/PROPELLER
Fig. 87 Rear Retainer Bushing Installation
1 - REAR RETAINER BUSHING
2 - INSTALLER 8157
Fig. 88 Install Rear Retainer Seal
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL D-163
into
AN