Dodge Dakota Sport 2001 Service Manual page 1127

9 - 98 ENGINE 3.9L
CRANKSHAFT OIL SEAL - REAR (Continued)
ble bearing cap to cylinder block immediately after
sealant application.
(6) To align the bearing cap, use cap slot, align-
ment dowel, and cap bolts. DO NOT remove excess
material after assembly. DO NOT strike rear cap
more than two times for proper engagement.
(7) Install the rear main bearing cap with cleaned
and oiled cap bolts. Alternately tighten the cap bolts
to 115 N·m (85 ft. lbs.) torque.
(8) Install oil pump (Refer to 9 - ENGINE/LUBRI-
CATION/OIL PUMP - INSTALLATION).
(9) Apply Mopar GEN II Silicone Rubber Adhe-
sive Sealant, or equivalent, at bearing cap-to-block
joint to provide cap to block and oil pan sealing.
Apply enough sealant so that a small amount is
squeezed out. Withdraw nozzle and wipe excess seal-
ant off the oil pan seal groove.
(10) Immediately install the oil pan (Refer to 9 -
ENGINE/LUBRICATION/OIL PAN - INSTALLA-
TION).
DISTRIBUTOR BUSHING
REMOVAL
(1) Remove distributor (Refer to 8 - ELECTRICAL/
IGNITION CONTROL/DISTRIBUTOR - REMOVAL).
(2) Remove the intake manifold (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
REMOVAL).
(3) Insert Distributor Drive Shaft Bushing Puller
Tool C-3052 into old bushing and thread down until a
tight fit is obtained (Fig. 37) .
(4) Hold puller screw and tighten puller nut until
bushing is removed.
Fig. 37 Distributor Driveshaft Bushing Removal
1 - SPECIAL TOOL C-3052
2 - BUSHING
INSTALLATION
tributor Drive Shaft Bushing Driver/Burnisher Tool
C-3053. Insert the tool and bushing into the bore.
hammer (Fig. 38) .
1 - SPECIAL TOOL C-3053
2 - BUSHING
the bushing is expanded tight in the block and bur-
nished to correct size (Fig. 39). DO NOT ream this
bushing.
CAUTION: This procedure MUST be followed when
MANIFOLD -
installing a new bushing or seizure to shaft may
occur.
1 - SPECIAL TOOL C-3053
2 - BUSHING
ENGINE/MANIFOLDS/INTAKE
INSTALLATION).
(1) Slide new bushing over burnishing end of Dis-
(2) Drive bushing and tool into position, using a
Fig. 38 Distributor Driveshaft Bushing Installation
(3) As the burnisher is pulled through the bushing,
Fig. 39 Burnishing Distributor Bushing
(4) Install the intake manifold. (Refer to 9 -
(5) Install the distributor.
AN
MANIFOLD -