Dodge Dakota Sport 2001 Service Manual page 1346

AN
FUEL TANK (Continued)
(1) Remove fuel tank filler tube cap.
(2) Perform Fuel System Pressure Release proce-
dure.
(3) Disconnect negative battery cable at battery.
(4) Disconnect quick-connect fuel line at fuel rail.
Refer to Quick-Connect Fittings for procedures.
(5) The hose from the gasoline draining station
must be adapted into the 5/16" quick-connect fitting
on disconnected fuel line. One way to accomplish this
is to obtain a 5/16" test fitting such as from Snap-On
Fuel Injection Adapter Set # FIDA44. Snap the fit-
ting into the disconnected fuel line and attach hose
from gasoline draining station.
(6) Operate the gasoline draining station to drain
fuel tank. As an alternative procedure, the electric
fuel pump may be activated. Refer to DRB scan tool
for fuel pump activation procedures. Activate electric
fuel pump, or gasoline draining station, and drain
tank until empty. If electric fuel pump is not operat-
ing, the gasoline draining station must be used.
(7) Raise vehicle and remove splash shield in front
of left/rear wheelhouse.
(8) Remove hose clamps and disconnect rubber fill
and vent hoses (Fig. 29) at fill and vent tubes (Fig.
28). Do not disconnect hoses at fuel tank.
1 - FUEL TANK (4—DOOR)
2 - TANK FITTINGS
3 - FILL HOSE
4 - VENT HOSE
5 - FUEL TUBE ASSEMBLY
6 - VENT HOSE
1 - FUEL FILL TUBE
2 - L.R. BRAKE DRUM
3 - FUEL VENT TUBE
Fig. 29 Fuel Tank and Hoses
7 - TANK FITTINGS
8 - FUEL TANK (4—DOOR)
9 - FILL HOSE
10 - CLAMPS
FUEL DELIVERY
Fig. 28 Fuel Fill and Vent Tubes
14 - 19