Dodge Dakota Sport 2001 Service Manual page 1379

14 - 52 FUEL INJECTION
THROTTLE BODY (Continued)
A (factory adjusted) set screw is used to mechani-
cally limit the position of the throttle body throttle
plate. Never attempt to adjust the engine idle
speed using this screw. All idle speed functions are
controlled by the PCM.
REMOVAL - 3.9L/5.2L/5.9L
A (factory adjusted) set screw is used to mechani-
cally limit the position of the throttle body throttle
plate. Never attempt to adjust the engine idle
speed using this screw. All idle speed functions are
controlled by the powertrain control module (PCM).
(1) Remove the air duct at throttle body.
(2) Disconnect throttle body electrical connectors
at MAP sensor, IAC motor and TPS (Fig. 51).
Fig. 51 Sensor Electrical Connectors—3.9/5.2/5.9L
Engines—Typical
1 - MAP SENSOR
2 - IDLE AIR CONTROL MOTOR
3 - THROTTLE POSITION SENSOR
(3) Remove vacuum line at throttle body.
(4) Remove all control cables from throttle body
(lever) arm. Refer to the Accelerator Pedal and Throttle
Cable section of this group for additional information.
(5) Remove four throttle body mounting bolts (Fig.
52).
(6) Remove throttle body from intake manifold.
(7) Discard old throttle body-to-intake manifold
gasket.
REMOVAL - 2.5L
A (factory adjusted) set screw is used to mechani-
cally limit the position of the throttle body throttle
plate. Never attempt to adjust the engine idle
speed using this screw. All idle speed functions are
controlled by the powertrain control module (PCM).
Fig. 52 Throttle
1 - THROTTLE BODY MOUNTING BOLTS (4)
2 - THROTTLE BODY
(1) Remove air duct at throttle body.
(2) Disconnect throttle body electrical connectors
at MAP sensor, IAC motor and TPS (Fig. 53).
Fig. 53 Throttle Body—2.5L Engine
1 - IDLE AIR CONTROL MOTOR
2 - IAT SENSOR
3 - THROTTLE BODY
4 - THROTTLE POSITION SENSOR
5 - MAP SENSOR
6 - IDLE AIR CONTROL PASSAGE INLET
7 - THROTTLE BODY MOUNTING BOLTS (4)
AN