Dodge Dakota Sport 2001 Service Manual page 1199

9 - 170 ENGINE 4.7L
CRANKSHAFT MAIN BEARINGS (Continued)
Fig. 63 Main Bearing Markings on Target Wheel
1 - REARMOST CRANKSHAFT COUNTER WEIGHT
2 - TARGET WHEEL
3 - MAIN BEARING SELECT FIT MARKINGS
MAIN BEARING SELECTION CHART—4.7L
GRADE SIZE mm
(in.)
MARKING
A 0.008 mm
U/S
(0.0004 in.)
U/S
B NOMINAL
C 0.008 mm
O/S
(0.0004 in.)
O/S
INSPECTION
Wipe the inserts clean and inspect for abnormal
wear patterns and for metal or other foreign material
imbedded in the lining. Normal main bearing insert
wear patterns are illustrated (Fig. 64).
NOTE: If any of the crankshaft journals are scored,
the crankshaft must be repaired or replaced.
Inspect the back of the inserts for fractures, scrap-
ings or irregular wear patterns.
Inspect the upper insert locking tabs for damage.
FOR USE WITH
JOURNAL SIZE
63.488–63.496 mm
(2.4996–2.4999 in.)
63.496–63.504 mm
(2.4999–2.5002 in.)
63.504–63.512 mm
(2.5002–2.5005 in.)
Fig. 64 Main Bearing Wear Patterns
1 - UPPER INSERT
2 - NO WEAR IN THIS AREA
3 - LOW AREA IN BEARING LINING
4 - LOWER INSERT
Replace all damaged or worn bearing inserts.
CRANKSHAFT OIL SEAL -
FRONT
REMOVAL
(1) Disconnect negative cable from battery.
(2) Remove accessory drive belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL).
(3) Remove A/C compressor mouning fasteners and
set aside.
(4) Drain cooling system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
(5) Remove upper radiator hose.
(6) Disconnect electrical connector for fan mounted
inside radiator shroud.
(7) Remove radiator shroud attaching fasteners.
NOTE: Transmission cooler line snaps into shroud
lower right hand corner.
(8) Remove radiator cooling fan and shroud (Refer
to 7 - COOLING/ENGINE/RADIATOR
REMOVAL).
(9) Remove crankshaft damper bolt.
(10) Remove damper using Special Tools 8513
Insert and 1026 Three Jaw Puller (Fig. 65).
(11) Using Special Tool 8511, remove crankshaft
front seal (Fig. 66).
AN
FAN -