AN
MANUAL - NV3500 (Continued)
Fig. 90 REVERSE IDLER ASSEMBLY POSITION
1 - OUTPUT SHAFT AND GEARTRAIN
2 - COUNTERSHAFT
3 - REVERSE IDLER ASSEMBLY
4 - PEDESTAL
Fig. 91 POSITIONING OUTPUT SHAFT BEARING
1 - ALIGNMENT TOOL
2 - OUTPUT SHAFT BEARING RETAINER
REAR HOUSING - 2WD
(1) Drive adapter housing alignment dowels back
into housing until dowels are flush with mounting
surface (Fig. 94).
(2) Apply liberal quantity of petroleum jelly to
countershaft rear bearing and bearing race.
(3) Install countershaft rear bearing in bearing
race (Fig. 95).
MANUAL - NV3500
Fig. 92 1-2 AND FIFTH-REVERSE
1 - INSERT ARM THROUGH 1-2 FORK
2 - 1-2 FORK
3 - FIFTH-REVERSE FORK
Fig. 93 SHIFT FORKS IN SYNCHRO
1 - SYNCHRO SLEEVES
2 - FORK ARMS
3 - SHIFT FORKS
CAUTION: Be sure the large diameter side of the
roller retainer faces the countershaft and the small
diameter side faces the race and housing (Fig. 96).
(4) Apply extra petroleum jelly to hold counter-
shaft rear bearing in place when housing is installed.
(5) Apply light coat of petroleum jelly to shift shaft
bushing/bearing in rear housing (Fig. 96).
(6) Reach into countershaft rear bearing with fin-
ger and push each bearing roller outward against
race. Then apply extra petroleum jelly to hold rollers
in place. This avoids having rollers becoming dis-
placed during housing installation.
21 - 63