Dodge Dakota Sport 2001 Service Manual page 1079

9 - 50 ENGINE 2.5L
FRONT MOUNT (Continued)
Fig. 65 Left Front Engine Mount Assembly
1 - STUD
2 - BOLT
3 - INSULATOR
4 - THROUGH BOLT
5 - FRAME
6 - NUT
7 - NUT
(7) Connect negative cable to battery.
REAR MOUNT
REMOVAL
(1) Disconnect the negative cable from the battery.
(2) Raise vehicle on hoist.
(3) Remove the through bolt and nut.
(4) Support the transmission with a jack. Raise
transmission slightly.
(5) Remove nuts securing insulator to crossmem-
ber (Fig. 66).
(6) Remove insulator.
INSTALLATION
(1) If the rear engine
removed, position the bracket to the transmission.
Tighten the stud nuts to 41 N·m (30 ft. lbs.) torque.
(2) Install the insulator onto the transmission
mounting crossmember. Tighten the stud nuts to 41
N·m (30 ft. lbs.) torque.
(3) Lower the transmission and engine while align-
ing the rear engine support bracket to the insulator.
support bracket was
Fig. 66 Rear Engine Support
1 - TRANSMISSION
2 - CROSSMEMBER
3 - INSULATOR
4 - SUPPORT BRACKET
(a) Install through-bolt in bracket and insulator.
Tighten through-bolt nut to 68 Nm (50 ft. lbs.)
torque.
(4) Remove transmission jack.
(5) Lower the vehicle.
(6) Connect the negative cable to the battery.
LUBRICATION
DESCRIPTION
A gear—type positive
mounted at the underside of the block opposite the
No. 4 main bearing.
OPERATION
The pump draws oil through the screen and inlet
tube from the sump at the rear of the oil pan. The oil
is driven between the drive and idler gears and
pump body, then forced through the outlet to the
block. An oil gallery in the block channels the oil to
the inlet side of the full flow oil filter. After passing
through the filter element, the oil passes from the
center outlet of the filter through an oil gallery that
channels the oil up to the main gallery which
extends the entire length of the block.
Galleries extend downward from the main oil gal-
lery to the upper shell of each main bearing. The
AN
displacement pump is