AN
EXHAUST MANIFOLD (Continued)
(3) Remove accessory drive belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL).
(4) Remove A/C compressor (Refer to 24 - HEAT-
ING & AIR CONDITIONING/PLUMBING/A/C COM-
PRESSOR - REMOVAL).
(5) Remove A/C accumulator support bracket fas-
tener.
(6) Drain coolant below heater hose level (Refer to
7 - COOLING - STANDARD PROCEDURE).
(7) Remove heater hoses at engine.
(8) Remove fasteners attaching exhaust manifold
heat shield.
(9) Remove heat shield.
(10) Remove upper exhaust manifold attaching fas-
teners.
ITEM
DESCRIPTION
1
Stud (Qty 2)
2
Bolt (Qty 4)
3
Stud (Qty 2)
(11) Raise vehicle on hoist.
(12) Disconnect exhaust pipe from manifold.
(13) Remove fasteners attaching starter. Move
starter aside.
(14) Remove lower exhaust manifold attaching fas-
teners.
(15) Remove exhaust manifold and gasket (Fig.
118). Manifold is removed from below the engine
compartment.
LEFT EXHAUST MANIFOLD
(1) Disconnect negative cable for battery.
(2) Hoist vehicle.
(3) Disconnect exhaust pipe at manifold.
(4) Lower vehicle.
Fig. 118 Exhaust Manifold—Right
TORQUE
25 N·m (18 ft. lbs.)
ITEM
DESCRIPTION
4
Nut (Qty 2)
5
Nut (Qty 2)
ENGINE 4.7L
9 - 195
TORQUE
8 N·m (72 in. lbs.),
then loosen 45
degrees