Dodge Dakota Sport 2001 Service Manual page 1137

9 - 108 ENGINE 3.9L
REAR MOUNT (Continued)
Fig. 56 Rear Insulator Manual Transmission—2WD
1 - TRANSMISSION EXTENSION
2 - INSULATOR
3 - CROSSMEMBER
INSTALLATION
2WD
(1) If the engine support bracket (Automatic
Transmissions) was removed, position the bracket to
the transmission extension (Fig. 55). Tighten the
bolts to 68 N·m (50 ft. lbs.) torque.
NOTE: AUTOMATIC TRANSMISSION
• Install the insulator onto crossmember. Tighten
the stud nuts to 41 N·m (30 ft. lbs) torque.
• Lower the transmission and engine while align-
ing the engine support bracket to the insulator.
• Install
thru-bolt
Tighten thru-bolt nut to 68 N·m (50 ft. lbs.) torque.
NOTE: MANUAL TRANSMISSION
• Install the insulator onto crossmember. Tighten
the stud nuts to 41 N·m (30 ft. lbs) torque.
• Lower the transmission and engine while align-
ing the insulator studs into the transmission exten-
sion.
• Install the stud nuts. Tighten the stud nuts to
41 N·m (30 ft. lbs) torque.
(2) Remove transmission jack.
(3) Lower the vehicle.
(4) Connect the negative cable to the battery.
in bracket and insulator.
Fig. 57 Rear Insulator Automatic Transmission—
1 - AUTOMATIC TRANSMISSION
2 - INSULATOR BRACKET
3 - INSULATOR
4 - CROSSMEMBER
4WD
NOTE: AUTOMATIC TRANSMISSION
• If the insulator bracket was removed, install the
bracket to the transmission (Fig. 57). Tighten the
bolts to 68 N·m (50 ft. lbs.) torque.
• Install the bolts holding insulator to insulator
bracket. Tighten the bolts to 68 N·m (50 ft. lbs.)
torque.
• Lower rear of transmission while aligning the
insulator studs into the mounting support bracket.
Install stud nuts and tighten to 68 N·m (50 ft. lbs.)
torque.
NOTE: MANUAL TRANSMISSION
• Install the bolts holding insulator to insulator
bracket. Tighten the bolts to 68 N·m (50 ft. lbs.)
torque.
4WD
AN