Dodge Dakota Sport 2001 Service Manual page 1352

AN
QUICK CONNECT FITTING (Continued)
(6) Verify a locked condition by firmly pulling on
fuel tube and fitting (15-30 lbs.).
(7) Latch Clip Equipped: Install latch clip (snaps
into position). If latch clip will not fit, this indi-
cates fuel line is not properly installed to fuel
rail (or other fuel line). Recheck fuel line con-
nection.
(8) Connect negative cable to battery.
(9) Start engine and check for leaks.
ROLLOVER VALVE
DESCRIPTION
The fuel tank on 2-door models is equipped with 1
rollover valve. This valve is located on the top of the
fuel tank (Fig. 41). The fuel tank on 4-door models is
equipped with 2 rollover valves. These valves are
also located on the top of the fuel tank (Fig. 42).
Fig. 41 Rollover Valve Location (2–Door Models)
1 - FILL HOSE
2 - VENT HOSE
3 - ROLLOVER VALVE
4 - LOCKNUT
5 - FUEL PUMP MODULE
6 - FUEL TANK
7 - FUEL FILTER/FUEL PRESSURE REGULATOR
Fig. 42 Rollover Valve Locations (4–Door Models)
1 - FUEL FILTER/FUEL PRESSURE REGULATOR
2 - ROLLOVER VALVE
3 - FUEL TANK SHIELD
4 - LOCKNUT
5 - FUEL PUMP MODULE
6 - ROLLOVER VALVE
7 - FUEL TANK
8 - FILL HOSE
9 - VENT HOSE
10 - PIGTAIL HARNESS
OPERATION
The rollover valve(s) will prevent fuel flow through
the fuel tank vent (EVAP) hoses in the event of an
accidental vehicle rollover. The EVAP canister draws
fuel vapors from the fuel tank through this valve(s).
The valve(s) cannot be serviced separately. If
replacement is necessary, the fuel tank must be
replaced. Refer to Fuel Tank Removal/Installation.
REMOVAL
The rollover valves(s) are/is molded into the fuel
tank and are not serviced separately. If replacement
is necessary, the fuel tank must be replaced. Refer to
Fuel Tank Removal/Installation.
INSTALLATION
The rollover valves(s) are/is molded into the fuel
tank and are not serviced separately. If replacement
is necessary, the fuel tank must be replaced. Refer to
Fuel Tank Removal/Installation.
FUEL DELIVERY 14 - 25