Dodge Dakota Sport 2001 Service Manual page 1370

AN
INTAKE AIR TEMPERATURE SENSOR (Continued)
REMOVAL - 4.7L
The Intake Manifold Air Temperature (IAT) sensor
is installed into the intake manifold plenum near the
left side of the throttle body (Fig. 37).
Fig. 37 Intake Manifold Air Sensor Location—4.7L
V-8 Engine
1 - THROTTLE BODY
2 - TPS
3 - IAC MOTOR
4 - IAT SENSOR
5 - MOUNTING SCREWS
(1) Disconnect electrical connector from sensor.
(2) Remove sensor from intake manifold.
REMOVAL - 2.5L
The intake manifold air temperature sensor is
located in the intake manifold (Fig. 38).
(1) Remove air duct at throttle body.
(2) Disconnect electrical connector at sensor (Fig.
38).
(3) Remove sensor from intake manifold.
INSTALLATION - 3.9L/5.2L/5.9L
The intake manifold air temperature sensor is
located in the front/side of the intake manifold (Fig.
36).
Fig. 38 Intake Manifold Air Temperature Sensor—
2.5L Engine
1 - FUEL PRESSURE TEST PORT
2 - ELECTRICAL CONNECTOR
3 - INTAKE MANIFOLD AIR TEMPERATURE SENSOR
4 - FUEL INJECTOR
(1) Install sensor to intake manifold. Tighten to 28
N·m (20 ft. lbs.) torque.
(2) Install electrical connector.
(3) Install air duct at throttle body.
INSTALLATION - 4.7L
(1) Install sensor into intake manifold. Tighten
sensor to 28 N·m (20 ft. lbs.) torque.
(2) Connect electrical connector to sensor.
INSTALLATION - 2.5L
The intake manifold air temperature sensor is
located in the intake manifold (Fig. 38).
(1) Install sensor to intake manifold. Tighten to 28
N·m (20 ft. lbs.) torque.
(2) Install electrical connector.
(3) Install air duct at throttle body.
MAP SENSOR
DESCRIPTION - EXCEPT 4.7L
The Manifold Absolute Pressure (MAP) sensor is
attached to the side of the engine throttle body with
2 screws. The sensor is connected to the throttle body
with a rubber L-shaped fitting.
FUEL INJECTION 14 - 43