Installation - Dodge Dakota Sport 2001 Service Manual

21 - 536 AUTOMATIC TRANSMISSION - 45RFE
VALVE BODY (Continued)
(6) Install the screws to hold the transfer plate to
the valve body. Tighten the screws to 5.6 N·m (50 in.
lbs.).
(7) Install the accumulator pistons and springs
into the valve body in the location from which they
were removed. Note that all accumulators except the
overdrive have two springs. The overdrive accumula-
tor piston has only one spring.
(8) Position the accumulator cover onto the valve
body.
(9) Install the screws to hold the accumulator
cover onto the valve body. Tighten the screws to 4.5
N·m (40 in. lbs.).
(10) Install the TRS selector plate onto the valve
body and the manual valve.
(11) Install the solenoid and pressure switch
assembly onto the valve body.
(12) Install the screws to hold the solenoid and
pressure switch assembly onto the valve body.
Tighten the screws to 5.7 N·m (50 in. lbs.). Tighten
the screws adjacent to the arrows cast into the bot-
tom of the transfer plate first.
(13) Position the detent spring onto the valve body.
(14) Install the screw to hold the detent spring
onto the valve body. Tighten the screw to 4.5 N·m (40
in. lbs.).
(15) Install new clutch passage seals onto the
valve body, if necessary

INSTALLATION

(1) Check condition of seals on valve body and the
solenoid and pressure switch assembly. Replace seals
if cut or worn.
(2) Place TRS selector plate in the PARK position.
(3) Place the transmission in the PARK position.
(4) Lubricate seal on the solenoid and pressure
switch assembly connector with petroleum jelly.
(5) Position valve body in transmission and align
the manual lever on the valve body to the pin on the
transmission manual shift lever.
(6) Seat valve body in case and install one or two
bolts to hold valve body in place.
(7) Tighten valve body bolts alternately and evenly
to 12 N·m (105 in. lbs.) torque.
(8) Install new fluid filter on valve body. Tighten
filter screws to 4.5 N·m (40 in. lbs.) torque.
(9) Connect the solenoid and pressure switch
assembly connector.
(10) Install oil pan. Tighten pan bolts to 12 N·m
(105 in. lbs.) torque.
(11) Lower vehicle and fill transmission with
Mopar® ATF +4, type 9602, fluid.
(12) Check and adjust gearshift cable, if necessary.
AN