Dodge Dakota Sport 2001 Service Manual page 1136

AN
REAR MOUNT (Continued)
Fig. 54 Engine Mount
1 - NUT
2 - ENGINE SUPPORT BRACKET
3 - INSULATOR
4 - NUT
5 - THROUGH BOLT
6 - FRAME
7 - FRONT AXLE
REAR MOUNT
REMOVAL
2WD
(1) Disconnect the negative cable from the battery.
(2) Raise the vehicle on a hoist.
(3) Support the transmission with a jack.
NOTE: AUTOMATIC TRANSMISSION
• Remove engine support bracket—insulator thru-
bolt (Fig. 55).
• Raise the transmission and engine slightly.
• Remove stud nuts attaching insulator to cross-
member (Fig. 55). Remove insulator.
NOTE: MANUAL TRANSMISSION
• Remove the stud nuts attaching the insulator to
the transmission extension (Fig. 56).
• Raise the transmission and engine slightly.
• Remove stud nuts attaching insulator to cross-
member (Fig. 56). Remove insulator.
Fig. 55 Rear Insulator Automatic Transmission—
1 - ENGINE SUPPORT BRACKET
2 - THROUGH BOLT
3 - CROSSMEMBER
4 - INSULATOR
5 - TRANSMISSION EXTENSION
4WD
(1) Disconnect the negative cable from the battery.
(2) Raise the vehicle on a hoist.
(3) Support the transmission with a transmission
jack.
NOTE: AUTOMATIC TRANSMISSION
• Remove stud nuts holding the insulator to the
crossmember (Fig. 57).
• Raise rear of transmission SLIGHTLY.
• Remove bolts holding the insulator to the insu-
lator bracket (Fig. 57). Remove the insulator.
NOTE: MANUAL TRANSMISSION
• Remove stud nuts holding the insulator to the
crossmember (Fig. 58).
• Raise rear of transmission SLIGHTLY.
• Remove bolts holding the insulator to the trans-
mission (Fig. 58). Remove the insulator.
ENGINE 3.9L 9 - 107
2WD