IBM power PS700 Problem Determination And Service Manual page 273

4. Does the blade server have Fibre Channel adapters?
Yes "Save vfchost map data" on page 218. Then, continue with the next step.
No Continue with the next step.
5. Shut down the operating system, turn off the blade server, and remove the blade server from the
BladeCenter unit. See "Removing the blade server from a BladeCenter unit" on page 235.
6. Carefully lay the blade server on a flat, static-protective surface, with the cover side up.
7. Open and remove the blade server cover. See "Removing the blade server cover" on page 237.
8. Remove the blade server bezel assembly. See "Removing the bezel assembly" on page 240.
9. Remove any of the installed components listed below from the system board; then, place them on a
non-conductive surface or install them on the new system board and chassis assembly.
v I/O expansion card. See "Removing and installing an I/O expansion card" on page 246.
v Hard disk drives. See "Removing a drive" on page 241.
v DIMMs. See "Removing a memory module" on page 244.
v Management card. See "Removing the tier 2 management card" on page 255.
v Battery. See "Removing the battery" on page 250.
10. Touch the static-protective package that contains the system-board and chassis assembly to any
unpainted metal surface on the BladeCenter unit or any unpainted metal surface on any other
grounded rack component; then, remove the assembly from its package.
11. Install any of the components listed below that were removed from the old system-board and chassis
assembly.
v I/O expansion card. See "Removing and installing an I/O expansion card" on page 246.
v Hard disk drives. See "Installing a drive" on page 242.
v DIMMs. See "Installing a memory module" on page 245.
v Management card. See "Installing the tier 2 management card" on page 256.
v Battery. See "Installing the battery" on page 251.
Note: Install a DIMM filler or a hard drive filler in any location where a DIMM or hard drive is not
present to avoid machine damage.
12. Install the bezel assembly. See "Installing the bezel assembly" on page 240 for instructions.
13. Install and close the blade server cover. See "Installing and closing the blade server cover" on page
239.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade server cover before installing the blade server.
Chapter 4. Removing and replacing blade server components
261