IBM power PS700 Problem Determination And Service Manual page 176

Table 27. A00-FF0 through A24-xxx SRNs (continued)
SRN
A0D-09x
A0D-18x
A0D-19x
A0D-21x
A0D-23x
A0D-24x
A0D-31x
A0D-35x
164
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
Description
Service Processor error accessing Vital
Product Data EEPROM.
Service Processor detected NVRAM
error.
Service Processor error accessing Real
Time Clock/Time-of-Day Clock.
Service Processor detect error with
Time-of-Day Clock backup battery.
Loss of heart beat from Service
Processor.
Service Processor detected a
surveillance time-out.
Error detected while handling an
attention/interrupt from the system
hardware.
Mainstore or Cache IPL Diagnostic
Error.
FRU/action
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.