IBM power PS700 Problem Determination And Service Manual page 216

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 3, "Parts listing, Type 8406," on page 229 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Isolation
Symptom
Procedure Code
FSPSP06 The service processor
reported a suspected
intermittent problem.
FSPSP07 The time of day has
been reset to the
default value.
FSPSP09 A problem has been
detected with a
memory DIMM, but
it cannot be isolated
to a specific memory
DIMM.
204
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
Action
Contact IBM Support.
1. Use the chdate command to set the Virtual I/O Server date and time,
using one of the following syntaxes:
chdate [-year YYyy]
[-month mm]
[-day dd]
[-hour HH]
[-minute MM]
[-timezone TZ]
chdate mmddHHMM[YYyy|yy]
[-timezone TZ]
2. If the problem persists, replace the battery, as described in
"Removing the battery" on page 250 and "Installing the battery" on
page 251.
Replace the CRU called out after this FSPSP call. If the CRU that is
called out is a DIMM CRU, perform the following procedure:
1. Replace both memory DIMMs of the pair on the microprocessor that
contains the failing CRU:
DIMM 1 (Px-C1)
For P1-C1, replace DIMMs 1 and 3; for P2-C1, replace
DIMMs 9 and 11.
DIMM 2 (Px-C2)
Replace DIMMs 2 and 4, or DIMMs 10 and 12.
DIMM 3 (Px-C3)
Replace DIMMs 1 and 3, or DIMMs 9 and 11.
DIMM 4 (Px-C4)
Replace DIMMs 2 and 4, or DIMMs 10 and 12.
DIMM 5 (Px-C5)
Replace DIMMs 5 and 7, or DIMMs 13 and 15.
DIMM 6 (Px-C6)
Replace DIMMs 6 and 8, or DIMMs 14 and 16.
DIMM 7 (Px-C7)
Replace DIMMs 5 and 7, or DIMMs 13 and 15.
DIMM 8 (Px-C8)
Replace DIMMs 6 and 8, or DIMMs 14 and 16.
2. See "Removing a memory module" on page 244 for location
information and the removal procedure.
3. Install new memory DIMMs, as described in "Installing a memory
module" on page 245.
See "Supported DIMMs" on page 4 for more information.