Installing The Blade Server Cover - IBM BladeCenter HS21 Series Problem Determination And Service Manual

Installing the blade server cover

To install the blade server cover, complete the following steps.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Attention:
cover is installed and closed. Do not attempt to override this protection.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Lower the cover so that the slots at the rear slide down onto the pins at the rear
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade server into the BladeCenter unit (see "Installing the blade
Blade-cover
release
You cannot insert the blade server into the BladeCenter unit until the
on page 75.
of the blade server. Before closing the cover, check that all components are
installed and seated correctly and that you have not left loose tools or parts
inside the blade server.
If a Memory and I/O Expansion Blade is not installed on the blade server, make
sure that the power jumper is installed in power connector J164 (see "Installing
the power jumper" on page 100 for instructions).
server in a BladeCenter unit" on page 78 for instructions).
Blade-cover
release
Chapter 4. Removing and replacing blade server components
81