IBM power PS700 Problem Determination And Service Manual page 156

Table 25. 101-711 through FFC-725 SRNs (continued)
SRN FFC
252B-719 252B
252B-720 252B
252B-721 252B
252B-722 252B
252B-723 252B
254E-201 254E 221
254E-601 254
254E-602 254
254E-603 254
254E-604 254
254E-605 254
254E-606 254
254E-701 254E 221
254E-702 254E 221
2567-xxx 2567
144
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
Description and Action
Device bus termination power lost or not detected.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 84.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board.
Adapter detected device bus failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 84.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board.
Temporary adapter detected device bus failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 84.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board.
Device bus interface problem.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 84.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board.
Device bus interface problem.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 84.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board.
Adapter configuration error. Go to "Performing the checkout procedure" on page
184.
Error log analysis indicates adapter failure. Go to "Performing the checkout
procedure" on page 184.
Error log analysis indicates an error attention condition. Go to "Performing the
checkout procedure" on page 184.
Error log analysis indicates that the microcode could not be loaded on the adapter.
Go to "Performing the checkout procedure" on page 184.
Error log analysis indicates a permanent adapter failure. Go to "Performing the
checkout procedure" on page 184.
Error log analysis indicates permanent adapter failure is reported on the other port
of this adapter. Go to "Performing the checkout procedure" on page 184.
Error log analysis indicates adapter failure. Go to "Performing the checkout
procedure" on page 184.
Error log analysis indicates permanent adapter failure. Go to "Performing the
checkout procedure" on page 184.
Error log analysis indicates permanent adapter failure is reported on the other port
of this adapter. Go to "Performing the checkout procedure" on page 184.
USB integrated system-board and chassis assembly. Go to "Performing the checkout
procedure" on page 184.