Removing The Bezel Assembly; Installing The Bezel Assembly - IBM power PS700 Problem Determination And Service Manual

3. Pivot the cover to the closed position until the releases (as shown by 2 ) click into place in the cover.
4. Install the blade server into the BladeCenter unit. See "Installing the blade server in a BladeCenter
unit" on page 236.

Removing the bezel assembly

Remove the bezel assembly.
Figure 12. Removing the bezel assembly
1. Read the Safety topic and the "Installation guidelines" on page 233.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
BladeCenter unit. See "Removing the blade server from a BladeCenter unit" on page 235.
3. Carefully lay the blade server on a flat, static-protective surface, with the cover side up.
4. Open and remove the blade server cover. See "Removing the blade server cover" on page 237.
5. Press the cover-assembly release (as shown by 3 in Figure 12) on each side of the blade server and
pull the bezel assembly ( 4 ) away from the blade server approximately 1.2 cm (0.5 inch).
6. Disconnect the control-panel ( 1 ) from the control-panel connector ( 2 ).
7. Pull the bezel assembly away from the blade server.
8. If you are instructed to return the bezel assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the bezel assembly

Install the bezel assembly.
240
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)