Automated Attendant Pbr Start Time Selection - NEC Xen IPK Programming Manual

Xen IPK
Automated Attendant PBR
Start Time Selection
General Description
This Memory Block is used to specify whether the Push Button Receiver (PBR) can receive dual-
tone multi frequency (DTMF) signalling while the Automated Attendant is sending the message
or after the message is complete.
Display
Data
No.
0 9 : P B R
T I M E
Settings
LK 1 LK 2
FR AF
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 + KI
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
FR: While the Automated Attendant sends the message.
AF: After the Automated Attendant sends the message.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2, Guide to Feature Programming.
N
When FR is assigned, the Automated Attendant message send start time and the PBR connected to Automated
Attendant trunk start time are the same.

1-4-09, Automated Attendant PBR Start Time Selection

Setting
Title
Data
S T R T F R
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name
Programming Manual
1-4-09
System Mode
1
Submode
4
Data No.
09
PC Programming
+ AU
DRAFT 3
Chapter 1 – 175