NEC Xen IPK Programming Manual page 95

Xen IPK
Programming Procedures
3 Use the dial pad to enter the time required.
Note: J to move cursor left.
L to move cursor right.
Setting Data (Allow): Class 1 to Class 4: 000 to 999
sec
Limit
N
Press to write the data.
4
P
5 Press to go back on-line.
Related Programming
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
N
When all trunks in a particular Trunk Group are busy, the station user can dial an Access Code to queue on the busy
Trunk Group. When a Trunk (in that group) becomes idle, the queued station is signalled.
1-1-37, Trunk Queuing Timeout Selection
(Continued)
000 = No
Default values:
Class 1 to Class 4 = 10 secs
Programming Manual
DRAFT 3
Chapter 1 – 75