NEC Xen IPK Programming Manual page 335

Xen IPK
Related Programming (Continued)
M.B. Number
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection
1-15-13 Centralised Day/Night Switching for Remote Office Assignment
1-15-14 Centralised Day/Night Switching for Main Office Assignment
1-15-15 Centralised BLF Send Point Code Assignment
1-15-16 Centralised BLF Send Extension Number Assignment
1-15-17 Centralised BLF Send Time Assignment
1-15-18 Centralised BLF Display Extension Number Assignment
3-70 CIC Number Assignment
5-05 Common Signalling Channel Route Selection
1-1-05 Start Time Selection
1-5-02 SMDR Print Format
1-5-13 Printer Connected Selection
1-5-14 Printer Line Feed Control Selection
1-5-25 SMDR Valid Call Time Assignment
1-5-26 SMDR Incoming/Outgoing Print Selection
1-8-35 COM Port Baud Rate Setting Assignment
4-56 SMDR Telephone Print Selection
N
1. The Xen IPK can be only a Remote Office for a NEAX2000/2400 Billing Center Office.
When the
2.
necessary.
1-15-12, Centralised Billing – Point Code of Centre Office Assignment
is a tandem office and Billing Information is not required, this assignment is not
Xen IPK
Memory Block Name
Programming Manual
DRAFT 3
Chapter 1 – 315