NEC Xen IPK Programming Manual page 526

December 2004
1 C: Port Number of CO/PBX Line
T: Telephone Port Number (smallest number is displayed)
V: Voice Recording Service Package
–: No Display
B: BSU No.
H: CCH No.
U: HUB No.
: Enabled
O
Space: Disabled
Related Programming
M.B. Number
7-3-00 MIF (ACD) Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
7-3-03 MIF (UCD) Assignment
7-3-04 MIF (Caller ID) Assignment
1-2-04 Call Arrival Key Block Assignment
1-2-21 PHS Telephone Assignment
N
1. ETU interface cards are assigned automatically during initial power up.
2. ESI(8)-U( ) ETU with ports 01 and 02 cannot be changed.
3. When ETU system capacity is exceeded, ERROR is displayed on the LCD, and the Transfer key cannot be used to
write data.
4. When changing an interface slot assignment to a different ETU, use the following procedure:
a. Remove the ETU installed in the slot.
Power off ACD(8), VoIP, VMS, IPCA, or FMS ETU before removing it.
b. Program the slot for new ETU in this Memory Block.
c. Install the new ETU.
5. VMS(2)/FMS(2)-U( ) ETU must be assigned as a VMS(4)/FMS(4)-U( ) ETU.
6. Eight BSU(2)-U( ) ETUs can be installed in the EXP Electra Elite IPK. Only three can be installed in the Basic Electra
Elite IPK.
7. Page 2, LK 5 is used for indication only. The VDH2(8)-U( ) ETU cannot be assigned.
Refer to the Features and Specifications Manual, Universal Slots for maximum capacities
8.
DRAFT 3
506 – Chapter 1
Memory Block Name
NEC Business Solutions Ltd
Card Interface Slot Assignment, 7-1