Attendant Add-On Console To Telephone Port Assignment - NEC Xen IPK Programming Manual

Xen IPK
Attendant Add-On Console to
Telephone Port Assignment
General Description
Use this Memory Block to assign an Attendant Add-On Console to a telephone port number.
Display
Data
No. Title
0 1 : D S S
T I M E
Programming Procedures
1 Go off-line.
Press LK1 + LK6.
2
3 Use J to move cursor to the second Data No. position and press
4
Use the dial pad to enter the data.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
N
5 Press to write the data.
6 Change the data using the dial pad.
N
7 Press to write the data.
P
8 Press to go back on-line.
Related Programming
M.B. Number
7-2 Telephone Type Assignment
N
1. The telephone with an Attendant Add-On Console connected must be specified by port number.
2. A maximum of four Attendant Add-On Consoles can be connected to a system.
3. A maximum of four Attendant Add-On Consoles can be connected to one telephone.

1-6-00, Attendant Add-On Console to Telephone Port Assignment

DSS No. Setting
1~4 Data
1 = P 0 1
D I S P L A Y
A to access the Memory Block.
Default Values
DSS
Memory Block Name
Programming Manual
1-6-00
System Mode
1
Submode
6
Data No.
00
PC Programming
+ BTD
Tel Port No.
1 › 01
2 › 02
3 › 01
4 › 02
DRAFT 3
Chapter 1 – 197