Voice Prompt To Tone Assignment - NEC Xen IPK Programming Manual

Xen IPK
Voice Prompt to Tone
Assignment
General Description
Use this Memory Block to assign the voice prompt to each tone. Voice prompt is provided only
during the Internal Dial tone or Call Waiting tone.
Display
Data Table
No. No.
1 6 : 0 1 : D T
T I M E
Settings
LK 1 LK 2
Voice Voice
Prompt 1 Prompt 2
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 + AF
3 Press corresponding CO/PBX line key to change data option.
Note: Table No. 1: Dial tone
Table No. 2: Call Waiting tone
N
4 Press to write the data and advance to Table 02.
5 After entering last data, press
P
6 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2 Guide to Feature Programming.

1-8-16, Voice Prompt to Tone Assignment

Tone Setting
Name Data
= P R 1
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
N
to write the data.
Memory Block Name
Programming Manual
1-8-16
System Mode
1
Submode
8
Data No.
16
PC Programming
+ AR
Default Values
Dial Tone: Voice Prompt 1
Call Waiting Tone: Voice Prompt 2
DRAFT 3
Chapter 1 – 237