Automated Attendant Message To Trunk Selection - NEC Xen IPK Programming Manual

December 2004
Automated Attendant Message
to Trunk Selection
General Description
Use this Memory Block to assign the Automated Attendant Message per-CO/PBX Trunk. When
the Automated Attendant Message is assigned to each CO/PBX Trunk, the system automatically
answers the incoming call and sends an Automated Attendant Message to the calling party.
Display
CO/PBX
No. Data
(01~64) No.
0 1 / 3 8 : A A
T I M E
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Enter data using the dial pad.
Setting Data:
1~8 Automated Attendant Message 1~8
Note: Use the following to enter data:
R
: Next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The attendant telephone position must dial an Access Code to activate this feature.
DRAFT 3
378 – Chapter 1
Setting
Title Data
M S G = 1
D I S P L A Y
CH to access the Memory Block.
Default Values
Message 1

Automated Attendant Message to Trunk Selection, 3-38

NEC Business Solutions Ltd
System Mode
3
Submode
—
Data No.
38
PC Programming
+ AU
3-38