Dss Call Voice/Tone Signal Selection - NEC Xen IPK Programming Manual

December 2004
DSS Call Voice/Tone Signal
Selection
General Description
Use this Memory Block to specify which is to be used first, Voice or Tone signalling, when calling
an extension from an Attendant Add-On Console.
Display
Data
No.
0 3 : V O I C E
T I M E
Settings
LK 1 LK 2
Tone Voice
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK6
.
3 Use J to move cursor to the second Data No. position and press
4 Press the corresponding CO/PBX line key to change the data option.
N
Press to write the data.
5
P
6 Press to go back on-line.
Related Programming
M.B. Number
1-6-00 Attendant Add-On Console to Telephone Port Assignment
N
1. Voice/tone signalling can also be switched by dialling 1 from a station.
2. If tone signalling is programmed in this Memory Block, the called party cannot answer handsfree unless the Direct
Station Select (DSS) station switches it to Voice by dialling 1.
DRAFT 3
198 – Chapter 1
Setting
Data
C A L L
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
C to access the Memory Block.
Memory Block Name

DSS Call Voice/Tone Signal Selection, 1-6-03

NEC Business Solutions Ltd
1-6-03
System Mode
1
Submode
6
Data No.
03
PC Programming
+ BTD