NEC Xen IPK Programming Manual page 241

Xen IPK
Programming Procedures
3 Press the corresponding CO/PBX line key to enter data.
The LED indication changes to indicate the data each time a CO/PBX line key is pressed.
CO/PBX
Line Key LED
Data
Note: Use the following when entering data:
S
Press to go to the next page
T
Press to go to the previous page
N
Press key. Data for Class 01
4
N
5 Press to write the data for Class 15.
P
6 Press to go back on-line.
Related Programming
M.B. Number
4-17 Station to Class of Service Feature Assignment
N
1. System-Wide Reset selection resets the following: Timed Alarm, Call Forward-All Call, Do Not Disturb, Customised
Message, and Callback Request.
2. Password (Outgoing Restriction) selection cancels Station Lockout and default password for another station.
3. Sixteen Classes (00
restricting others.
4. At default, stations 100 and 101 are in class 00. All other stations are in class 15.
5. Stations are assigned to a Class of Service in Memory Block 4-17 Station to Class of Service Feature Assignment.
6. If Terminal Exchange Mode is enabled by user on Attendant Station the PC Programming is unavailable.
7. Terminal Exchange Mode must be set to OFF on the extension to enable PC connection to function.
1-8-07, Class of Service (Attendant) Feature Selection 1
(Continued)
Off On
Deny Allow
15 is displayed successively.
~
15) of feature restriction patterns allow a station user to activate particular features while
~
Refer to Table on following
page for default settings.
Memory Block Name
Programming Manual
DRAFT 3
Chapter 1 – 221