Tie Line Release Detect Time Selection - NEC Xen IPK Programming Manual

December 2004
Tie Line Release Detect Time
Selection
General Description
Use this Memory Block to specify the duration between the time when the circuit disconnection
is detected on the Tie line on the distant system side and the time when it is recognised as Tie
line release.
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 1 8 : R L S
T I M E
Settings
(Page 1)
LK 1 LK 2
0 ms. 130 ms.
LK 5 LK 6
520 ms. 650 ms.
(Page 2)
LK 1 LK 2
1040 ms. 1170 ms.
LK 5 LK 6
1560 ms. 1690 ms.
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
Press the corresponding CO/PBX line key to change the data option.
3
Note: The following are used when entering data:
S
to go to the next page
T
to go to the previous page
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
DRAFT 3
354 – Chapter 1
Setting Page
Title
Data No.
2 6 0 | 1
D I S P L A Y
LK 3
260 ms. 390 ms.
LK 7
780 ms. 910 ms.
LK 3
1300 ms. 1430 ms.
LK 7
1820 ms. 1950 ms.
to access the Memory Block.
AH
LK 4
LK 8
The shaded area indicates
the default setting.
LK 4
LK 8

Tie Line Release Detect Time Selection, 3-18

NEC Business Solutions Ltd
System Mode
3
Submode
—
Data No.
18
PC Programming
+ ALM
3-18