NEC Xen IPK Programming Manual page 545

Xen IPK
Timer
PBR Interdigit
Release Timer
Selection
System Refresh
Timer Assignment
VRS Message
Recording Time
Selection
ACD Hunt Timer
Trunk DTMF
Duration/Interdigit
Selection
Tie Line Prepause
Time Selection
Tie line Answer
Detect Time
Selection
Tie Line Release
Detect Time
Selection
Tie Line/CO/PBX
Incoming Signal
Detect Time
Selection
Tie Line Loop Off-
Guard Time
Selection
Tie Line Length of
Wink Signal
Selection
Section 5, Function Timer Chart
Function Timer Chart (Continued)
Table 1-3:
Memory
Definition
Block
Specify the interdigit release time
1-8-10
for the PBR.
Assign the system refresh time.
1-8-11
Specify the time length and
1-8-12
number of messages for each
VRS channel
Assigns the time value for hunting
1-8-40
among ACD/UCD agents that do
not answer.
Specify the tone duration and
3-15
interdigit time of DTMF signals
(Expressed as duration/interdigit
time).
Specify the prepause time for
3-16
when the originating side can
send dial pulse or DTMF to a
distant system.
Specify the duration between the
3-17
time when the receiving system
answers and the time when it is
recognised as an answer.
Specify the duration between the
3-18
circuit disconnection detection on
the Tie line on the distant system
side and the time it is recognised
as Tie Line Release.
Specify the time between the
3-19
detection of an incoming signal
from another Xen system and the
time when the acknowledgment
signal is sent (Expressed as Wink
Start/Delay/COI in ms.).
Assign loop off-guard protection to
3-20
prevent noise that may cause the
system to be unable to answer an
incoming Tie line.
Specify the time between the
3-21
incoming signal detection from
another Xen system and when the
acknowledgment signal is sent
out.
Programming Manual
Timing Value
Minimum Default
3 sec. 7 sec.
No Refresh 4 hr.
15 sec. 15 sec.
10 sec. 10 sec.
60/70 ms. 110/80 ms.
0 sec. 0 sec.
0 ms. 520 ms.
0 ms. 520 ms.
0/0/5 520/120/200
0 sec. 2 sec.
30 ms. 180 ms.
DRAFT 3
Maximum
10 sec.
24 hrs.
120 sec.
No Limit
810/190 ms.
13 sec.
1950 ms.
1950 ms.
1950/450/800
13 sec.
480 ms.
Chapter 1 – 525