Checking The Rear Brake Master Cylinder; Assembling The Rear Brake Master Cylinder; Installing The Rear Brake Master Cylinder - Yamaha MT-03 Service Manual

NOTE:
To collect any remaining brake fluid, place a
container under the master cylinder and the
end of the brake hose.
EAS22720
CHECKING THE REAR BRAKE MASTER
CYLINDER
1. Check:
• Brake master cylinder
Damage/scratches/wear
• Brake fluid delivery passages
(brake master cylinder body)
Obstruction Blow out with compressed air.
2. Check:
• Brake master cylinder kit
• Damage/scratches/wear
3. Check:
• Brake fluid reservoir
Cracks/damage
• Brake fluid reservoir diaphragm
Cracks/damage
4. Check:
• Brake hoses
Cracks/damage/wear
EAS22730
ASSEMBLING THE REAR BRAKE MASTER
CYLINDER
EWA13520
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake com-
ponents.
• Whenever a master cylinder is disassem-
bled, replace the piston seals and dust
seals.
Recommended fluid
DOT 4
Replace.
Replace.
Replace.
Replace.
Replace.
1. Install:
• Brake master cylinder kit
• Joint "1"
NOTE:
Turn the adjusting bolt "2" until the clearance
"a" is within the specified limits when install the
joint "1".
Clearance
2.1 mm (0.08 in)
2. Tighten:
• Nut "3"
Brake master cylinder adjusting
nut
18 Nm (1.8 m·kg, 13 ft·lb)
EAS22740
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• Brake master cylinder
• Pin "1"
• Washer "2"
• Cotter pin "3"
NOTE:
Install the cotter pin and bend the ends as
shown.
1
4-39
REAR BRAKE
2
a
3
1
New
2 3 New