EAS00346
REMOVING THE A.C. MAGNETO ROTOR
1. Remove:
• Torque limiter cover
CAUTION:
Do not remove the bearing "1".
2. Remove:
• A.C. magneto cover
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
3. Remove:
• A.C. magneto rotor nut "1"
• Washer
NOTE:
• While holding the A.C. magneto rotor "2" with
the sheave holder "3", loosen the A.C. mag-
neto rotor nut.
• Do not allow the sheave holder to touch the
projection "a" on the A.C. magneto rotor.
Sheave holder
90890-01701
STARTER CLUTCH AND A.C. MAGNETO
4. Remove:
1
• A.C. magneto rotor "1"
(with the flywheel puller "2")
• Woodruff key
NOTE:
Use the rotor puller.
CHECKING THE STATOR COIL AND
CRANKSHAFT POSITION SENSOR
1. Check:
• Stator coil
• Crankshaft position sensor
Damage
sensor/stator assembly.
5-54
3
1
Flywheel puller
90890-01362
1
2
Replace the crankshaft position
a
2