Installing The Fuel Pump; Installing The Fuel Hose; Checking The Fuel Sender - Yamaha MT-03 Service Manual

INSTALLING THE FUEL PUMP

1. Install:
• Fuel pump
NOTE:
• Do not damage the installation surfaces of the
fuel tank when installing the fuel pump.
• Always use a new fuel pump gasket.
• Align the projection "A" on the fuel pump with
the slot in the fuel pump bracket.
• Tighten the bolts to the specified torque in the
proper tightening sequence as shown.
• Install the fuel pump in the direction shown in
the illustration.
2. Tighten:
• Fuel pump bolts
Fuel pump bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)

INSTALLING THE FUEL HOSE

1. Install:
• Fuel hose
CAUTION:
When installing the fuel hose, be sure to
securely connect it.

CHECKING THE FUEL SENDER

This model is equipped with a self-diagnosis de-
vice for the fuel sender circuit. If the fuel sender
circuit is defective, the following cycle will be re-
peated until the malfunction is corrected.
• The fuel level warning light will flash four
times and then go off for 3.0 seconds if the
fuel sender circuit is in short circuit.
• The fuel level warning light will flash eight
times and then go off for 3.0 seconds if the fu-
el sender circuit is interrupted or the coupler
disconnected.
7-3
FUEL TANK