Yamaha MT-03 Service Manual page 120

CAUTION:
Do not overtighten the screw, otherwise the
lens may break.
REPLACING THE LICENSE PLATE
LIGHT BULB
1. Replace:
• License plate light bulb
a. Remove:
• Reinforcement plate bolts and nuts
• Reinforcement plate "1"
• License plate light bulb socket "2" (by pulling
it out)
• License plate light bulb "3" (by pulling it out)
NOTE:
When removing the license plate light bulb
socket, be careful not to pull too hard.
2
3
b. Install:
• License plate light bulb into the socket (by
pushing it in)
New
• License plate light bulb socket (by pushing
it in)
• Reinforcement plate
• Reinforcement plate bolts and nuts
c. Tighten:
• Reinforcement plate bolts and nuts
Reinforcement plate nut
7 Nm (0.7 m·kg, 5.1 ft·lb)
Reinforcement plate bolt (centre)
10 Nm (1.0 m·kg, 7.2 ft·lb)
Reinforcement plate bolt (upper)
10 Nm (1.0 m·kg, 7.2 ft·lb)
EAA01170
ADJUSTING THE HEADLIGHT BEAM
1. Adjust:
• Headlight beam (vertically)
a. Turn the adjusting screw "1" in direction "a"
or "b"
Direction (a)
Headlight beam is lowered
Direction (b)
Headlight beam is raised
1
3-31
ELECTRICAL SYSTEM
1
b
a