Checking The Cooling System - Yamaha MT-03 Service Manual

CAUTION:
• Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant check,
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
4. Check:
• Coolant level
NOTE:
Before checking the coolant level, wait a few
minutes until it settles.
EAS00104

CHECKING THE COOLING SYSTEM

1. Remove:
• Seats
Refer to "GENERAL CHASSIS" on page 4-1.
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
2. Check:
• Radiator "1"
• Radiator outlet hose "2"
• Radiator inlet hose "3"
• Water pump assembly
• Water pump outlet pipe "4"
• Water pump outlet hose "5"
Cracks/damage
Refer to "COOLING SYSTEM" on page 6-7.
Replace.
3. Install:
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Seats
Refer to "GENERAL CHASSIS" on page 4-1.
3-15
ENGINE