Yamaha MT-03 Service Manual page 167

4. Install:
• Front brake master cylinder "1"
• Front brake master cylinder holder "2"
NOTE:
• Make sure that the "UP" mark "a" with the
bracket is pointed upward.
• Align the punch mark "b" on the handlebar
with the gap of the master cylinder bracket.
Front brake master cylinder
holder bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
b
2
NOTE:
• Tighten the bolts in stages and maintain an
equal gap on each side of the bracket to
specification.
• Check the brake lever for smooth action.
WARNING
Proper cable routing is essential to assure
safe motorcycle operation. Refer to "CABLE
ROUTING" on page 2-40.
5. Install:
• Left handlebar switch "1"
NOTE:
Align the projection "a" on the left handlebar
switch with the hole in the handlebar.
Handlebar switch bolt
2 Nm (0.2 m·kg, 1.4 ft·lb)
1
a
4-44
1
WARNING
Proper cable routing is essential to assure
safe motorcycle operation. Refer to "CABLE
ROUTING" on page 2-40.
6. Install:
• Clutch cable "1"
• Cable boot "2"
NOTE:
• Lubricate the pivoting part "a" of the clutch
lever.
• Turn in the adjuster "b" on the lever holder un-
til tight. Next, align the slit in the adjuster and
cable socket with the slit in the lever holder.
• Insert the cable end into the lever hole. Next,
while pulling the outer cable in the direction
opposite to the lever, seat the outer cable into
the cable socket.
7. Connect:
• Clutch lever switch "3"
WARNING
Check the clutch lever for smooth action.
Refer to "CABLE ROUTING" on page 2-40.
HANDLEBAR
a
1